Champion 2000 Anleitung zur Fehlerbehebung

Door-type High Temperature DishwasherInstallation/Operation Manual with Service Replacement Parts 2674 N. Service Road, Jordan Station Ontario, C

2InstallationConverting Straight-through Operation to Corner OperationDishwashers are shipped from the factory for Straight-through operation. Refer

3Installation Converting Straight-through Operation to Corner OperationwallwallAATo convert track guides and door-lift for corner operation:1. Remov

4InstallationElectrical Connections ATTENTION A qualified electrician must connect the main incoming power to the dishwasher in accordance with all lo

5 A standard 3-phase operation dishwasher can be converted for 1-phase operation with the installation of a jumper wire on the main terminal and rew

6InstallationHot Water Connection NOTE:Plumbing connections must comply with all national and/or local plumbing and sanitary codes.The hot water conne

7InstallationNOTE:Consult a qualified chemical supplier for chemical supplies and chemical dispensing equipment.A commercial grade non-chlorinated det

8Initial Start-upInstallation Check List 1. Remove any protective lm from dishwasher. Check the interior for foreign material. 2. Make sure that t

9OperationNormal Operation ModeDoor Safety SwitchPower SwitchWash Temperature GaugeFinal Rinse Temperature GaugePressure GaugeIn-cycle LightFollow t

10OperationNormal Operation Mode (continued)Final RinsePressureWash TemperatureFinal RinseTemperatureWINSTON-SALEM,NCCHAMPION INDUSTRIES, INC.1003020P

11OperationRinse Sentry Operation Mode The nal rinse water temperature must be a minimum of 180ºF/82ºC during the final rinse cycle to ensure that a

COPYRIGHT © 2014 All rights reserved Printed in the USAFor future reference, record your dishwasher information in the box below. Model Number___

12After Each Meal Period or every 8 Hours of Operation. 1. Press the lighted power switch to the OFF position. The power switch light will go out an

13 CleaningCleaning and Maintenance At the End of the Day 1. Perform Steps 1-10 on the previous page.2. Remove the upper and lower rinse and wash sp

14Cleaning and MaintenanceMinerals accumulate on the interior surfaces of the dishwasher. The deposits have a white haze and, in cases of heavy accum

15Cleaning and MaintenanceMaintenanceDaily Maintenance1. Check all of the wash arm and rinse arm spray jets and clean as necessary.2. Make sure the

16TroubleshootingFollow the troubleshooting guide below in the event that your dishwasher does not operate as expected. Perform the basic checks belo

17Service Replacement PartsService Replacement PartsIllustrations PageWash Pump/Motor Assembly ...

18Wash Pump/Motor Assembly 1211101413987654123

19Item Part Description Qty. No. No.1 114134 SLINGER, WATER 12 114135 NUT 93 114136 SCREW 94 114137 BACKPLATE, PUMP 15 114138 GASKET, PU

20Booster Assembly6778451314161715131218192021221011927

21Item Part Description Qty. No. No.1 100184 NIPPLE, 3/4" NPT X CLOSE BRASS 2 2 100210 PLUG, 1/8" SST 13 100571 UNION, 3/4" N

http://www.championindustries.com/canada/registerREGISTER YOUR PRODUCT ONLINEMake sure you are connected to the internet then enter the address below.

22Control Panel Assembly248164832473335252041303649 23 514239344050444591018114346272837223121265

23Item Part Description Qty. No. No.Control Panel Assembly1 100003 NUT, HEX PLAIN 1/4-20 SST 82 100007 SCREW, TRUSS HD. 10-32 X 3/8" SST

24Wash and Rinse Spray Arm Assemblies372728293335343161524231714145876983219101211232018261821372531301322

25Item Part Description Qty. No. No.1 100135 GAUGE, PRESSURE 0-60 PSI 12 100156 LOCKNUT, 3/4" NPT BRASS 13 100171 BUSHING, RED. FACE 3/

26Hood and Door Assembly 14 11 25 12 4 2 17 15 13 9 7 16 21 11 10 10 20 20 4 6 24 18 5 1 3 4 8 3 6 26 22 24 19 23 4 21 27 27 28 29

27Item Part Description Qty. No. No. Hood and Door Assembly1 100002 BOLT, HEX HD., 1/4-20 X 1-3/8" SST 22 100738 BOLT, HEX HD., 1/4-20 X 1

28Track Assemby 5 6 7 9 3 4 1 2 8 11 10

29Item Part Description Qty. No. No.Track Assembly1 100003 HEX PLAIN NUT, 1/4-20 SST 62 100073 SCREW, TRUSS HD., 1/4-20 X 1/2" SST 63 10

30Wash Tank Heat, Drain, Screens, Hoses3410108592113111225131415161617181920212223241167

31Item Part Description Qty. No. No.Wash Tank Heat, Drain, Screens, Hoses1 107340 CLAMP, HOSE 42 114745 HOSE, DISCHARGE 13 104203 CLAMP, HOS

PRODUCT REGISTRATION BY FAX (336) 661-1660 in the USA1-(800) 204-0109 in CanadaIMPORTANT IMPORTANTModelSerial #Date of Installation:Company Name

32 32Item Part Description Qty. No. No.Dish Racks, Line Strainer, PRV1234

33Item Part Description Qty. No. No. Dish Racks, Line Strainer, PRV1 101273 DISH RACK, FLAT-BOTTOM AR 2 101285 DISH RACK, PEG AR3 110768 ST

34Timer Chart, Electrical SchematicIllustrations PageTimer Chart ...

35Timer ChartTIME CYCLE - DH/MD2000DWG. 114470-0/B3/10/09 L.B. 6010020 4030 50 70 9080 10010080 90705030 4020010 606010020 4030 50 70 9080 10010080 90

36Electrical SchematicBYDATEDESCRIPTIONREV.BREV.The Dishwashing Machine SpecialistsREV. DESCRIPTIONDATEBYCUSTOMER TO SUPPLY RATED VOLTA GE/PHASE/Hz,AS

37Electrical Schematic

38Blank PageThis Page Intentionally Left Blank

iRevision HistoryRevision Revised Serial Number Revision Date Pages Effectivity Description6.12.09 All D09037592 Re

iiLimited WarrantyLIMITED WARRANTYChampion Industries Inc. (herein referred to as Champion), 3765 Champion Blvd., Winston-Salem, North Carolina 27105

iiiRevision History ...iLimited Warranty .

ivModel DescriptionModel Description2000 SeriesHigh temperature hot water sanitizing dishwasher with built-in 40-70°F/22-82°C rise booster heater. Fi

1NOTE:The installation of your dishwasher must be performed by qualified service personnel. Problems due to improper installation are not covered by